BT UC-351GP/E-UK Instalační manuál stáhnout pdf (Strana 12)

BT Redcare Secure Issue 16 June 2010

The following General Purpose inputs (GPIP‟s) have specific purposes:

GPIP4

Will raise a Pin 4 alarm and trigger the RPS function on output pin 3.

GPIP11

When configured for BSIA Form 175 functionality, activates a response on output 1

(GPOP1) to interrogate local path fault, or raises a BSIA Form 175 Test alarm over

each signalling path.

GPIP12

Will raise a Pin 12 alarm for general use. Typically mapped as a tamper alarm at ARC.

GPIP13

Dedicated for AC fail indication, will raise a Pin 13 alarm after a delay of 7 minutes.

Alarm Panel Connection – Dial Capture

To use dial-capture, connect the alarm panels digicom line connectors to the Redcare Secure‟s

Alarm Panel interface J1000.

Pins 1, 2 - Alarm Panel In

Pins 3, 4 - Unused

Pins 5, 6 - Unused

The diagram below shows the alarm panel connection.

Figure 8 - J1000 Alarm Panel connection

Note: When using the alarm panel interface port to connect to the Redcare Secure unit,

there will be a delay between the alarm panel activating the dialler notification output and

the Redcare Secure sending the message to the ARC. The length of the delay may be up to

20 seconds and varies depending on the make and model of the alarm panel. Also, if the

panel goes off-hook but fails to dial within 10 seconds, a “Panel Dial fail” alarm will be

sent.

General Purpose Outputs (GPOP’s)

Three General Purpose outputs are provided. The outputs are open collector outputs (with 12V

pull-up). The outputs are rated to 30V.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 39 40

Žádné komentáře

BT UC-351GP/E-UK Instalační manuál Strana 12